1:/
Depress the stamp slightly as shown below and slide the inkpad out from
the stamp
2:/
Add a few drops of stamp pad ink to the pad
and the depress the stamp slightly again and re-insert the pad back into
the stamp
Use 5 to 10 drops for small to medium size
stamps and 10 to 15 drops for larger sizes
Use standard stamp pad ink. Ultimark,
Ultifast & Stampstore Model 850 ink is not suitable.
StampStore ST Series & Ultimark Stamps
Remove the red handle by holding the base of
the stamp and lift the handle off the stamp. Then add the required
amount of ink in drops to each well as shown on the bottom of your
stamp. Replace the handle. Allow the stamp to stand for 12 hours. Do not
over ink or the stamp will leak ink. If after 12 hours the imprint is
still faint add a few more drops to each well and let stand again for 12
hours.
Use Only StampStore model
850 ink or Ultimark ink. The use of any other inks will ruin the stamp
UltiFast Stamps
Remove the black handle by holding the base
of the stamp and lift the handle off the stamp. Unscrew the caps (anti
clockwise direction). Then add the required amount of ink in drops to
each well as shown on the bottom of your stamp. Replace the caps and
handle. Allow the stamp to stand for 12 hours. Do not over ink or the
stamp will leak ink. If after 12 hours the imprint is still faint add a
few more drops to each well and let stand again for 12 hours.
Use only UltiFast Ink. The use of any
other inks will ruin the stamp
